What are the reasons for oil leaks on CNC machining centres?

When Using A CNC Machining Center For Processing, It Is Inevitable To Encounter Some Problems. Of Course, When Encountering Problems, They Should Be Dealt With As Soon As Possible To Resume Production. Among The Problems Encountered, Oil Leakage Is One Of The More Common Phenomena. Compared With More Complex Problems, Oil Leakage Is Still Very Easy To Find Relatively Easy To Solve. First Of All, You Need To Find The Leaking Accessories Replace Them, But Some Situations That Cause Oil Leakage In The CNC Machining Center Need To Be Taken Seriously, Otherwise It Will Be Very Troublesome Even Cause The Machine Tool To Be Scrapped. Next, Let's Analyze The Causes Of Oil Leakage In The CNC Machining Center!

First Of All, If The Oil Is Changed According To Regulations, It Is Easy For The CNC Machining Center To Leak Oil. Secondly, There Are Also Some Reasons That Cause Oil Leakage In The CNC Machining Center During The Replacement Of Oil Products.

First, For Parts That Require High-Viscosity Lubricants, It Is Necessary To Pay Attention To Their Matching When Changing The Oil. If Low-Viscosity Lubricants Are Used, The Sealing Of Certain Parts Will Be Greatly Reduced, Resulting In Oil Leakage.

Second, Cleaning The Fuel Tank Also Plays A Very Important Role In Whether There Is Oil Leakage . When Changing The Oil, Dirt Is Often Easy To Form In The Fuel Tank. If It Is Cleaned In Time, It Is Easy To Cause Blockage, Etc., Resulting In Oil Leakage.

Third, The Amount Of Oil Added Should Be Too Large. If The Fuel Tank Is Too Full When Refueling, Oil Overflow May Occur, Especially In Some Parts That Need To Rotate.

[Solution] How To Prevent Oil Leakage In CNC Machining Center? Operators Should Also Pay Attention To The Following Points When Using CNC Machining Center To Process Workpieces:

(1) For The First Trial Cutting Process Of CNC Machining , The Single-Stage Operation Mode Should Be Used For Machining.

(2) When The CNC Milling Machine Starts Automatic Operation, The Rapid Rate Feed Rate S Are At The Lowest Gear, Then The Efficiency Is Improved After Cutting Into The Workpiece.

(3) When Operating The CNC Milling Machine Processing Program, You Need To Pay Attention To The Coordinate Display Of The CNC System.

(4) It Is Forbidden To Touch The CNC Milling Machine Tools Chips With Your Hands. The Chips Must Be Cleaned With A Brush.

The Analysis Of The Causes Of Oil Leakage In CNC Machining Centers Ends Here. Huiwen Zhizao Is A Machining Factory With More Than Ten Years Of CNC Machining Experience . It Has A Full Range Of Equipment, Including CNC Lathe/Milling/Grinding/Drilling/Machining. Partners With Precision Parts Processing Needs Are Welcome To Call Us For A Quote.